P64 reassembly

[limbo2]

Hi there. New here, and hope someone can help out with my new P64. Just installed a new trigger spring, but having difficulty reassembling. The disconnector arm won't stay in place to release the trigger. Any suggestions? If I hold it in place, it will engage. If I hold it upside down, it will sometimes engage. But when I go to put the grips on, it falls out of place. Any suggestions on how to get this back together? Thanks.

[7point62fmj]

Did you use this guide?
They have some trick about how to set the springs to get it back together.
Worked for me.
http://www.p64resource.com/board/P64_%20Assembly.pdf

[normsutton]

limbo2

http://www.p64resource.com/goods.php

go to the bottom of page

NORM