This is a handmade, heavy-stitched IWB rig by US GUNLEATHER. The leather used is 7-8oz American tanned cowhide. This pattern stays put, wears comfortably, and rides high enough for a sure grip but low enough to conceal perfectly. These are made to order, so please allow the current wait time to finish your order. (Wait time found at US GUNLEATHER)
Payment:

Ordering: Please visit US GUNLEATHER to order.

Trigger Return Spring and Slide Stop Spring by Norm Sutton
This is a new replacement spring for the P64 pistol by Norm Sutton.
Price: $6 shipped
Payment:

To order the trigger return spring : To order the slide stop spring :
Installation instructions:
The reason I have you cut the tabs on the springs the guns may vary.
Take the gun apart.
Put the gun in a plastic bag that you can see though and get both hands in.
This way you won’t lose the slide stop spring. Take the slide stop bar off.


Take trigger pin put into trigger and spring.
Tail of spring facing back then mark and cut.

Take trigger pin, trigger, and spring and put in trigger pin on the outside on the gun.
With trigger level , bend top of spring back so it’s just inside the hole mark then cut.

Take out trigger pin put trigger & spring up into the frame of the gun.
Use a tapered punch in the hole to hold spring & trigger in place.
Wiggle trigger tell you can get the trigger pin in place.
Then on the slide stop side take a small screw diver or dental instrument and hold spring tail down then put the trigger bar back on then let the tail of the spring up into the trigger bar stud.

Pull the trigger a couple of time to make sure every then works.
Then put the slide stop on.
This may take you a couple of times to these steps but this is the best way that I could come up with.
Hope the pictures help.
THANK YOU
NORM
NORMSUTTON@AOL.COM