I was told that much of the heavy recoil from the P-64's can be absorbed better by different grips.
Assuming this to be the case, and since I am a complete newbie to Radoms, I figured I'd ash the group what they use. My only point is the "new" grips must be good for CC as this will be my primary use for the P-64.
Grips for CCW & Recoil
- kilogulf59
- Member
- Posts: 51
- Joined: March 4th, 2008, 6:03 pm
- Location: Juneau County Wisconsin
- Contact:
Grips for CCW & Recoil
I use a an inner tube cut to fit over the grip. Can't say that it changes the recoil much but it feels better in my big hands.
I would think those Hogue grips would be the best bet.
I would think those Hogue grips would be the best bet.
[url=http://drugstore-onlinecatalog.com/]drugstore-onlinecatalog.com[/url]
Grips for CCW & Recoil
Hogue Handall Jr. is a good (but very snug) fit on the P-64 and it absorbs a lot of recoil. There is some good info on different installation techniques for this grip elsewhere on the P-64 board.
hangfire
hangfire
Grips for CCW & Recoil
For ~$2.50 you can get "Whatagrip" at Walmart. It's next to the tennis racquets. There's enough in there to do 2 P64s. It's cheap, it feels good, it's worth a shot... If you order the stuff on line, there's even some colors to choose from
![Image](http://img.tennis-warehouse.com/ProductImages/WAG.JPG)
here's the link to order online...candy stripe anyone?
Click me!
here's the link to order online...candy stripe anyone?
Click me!
- kilogulf59
- Member
- Posts: 51
- Joined: March 4th, 2008, 6:03 pm
- Location: Juneau County Wisconsin
- Contact:
Grips for CCW & Recoil
Thanks folks...I have to check out that cushion whatagrip....in black.
Grips for CCW & Recoil
Wonder if we would have enough members here that could get the Hogue brothers to make one of their outstanding soft rubber grips to fit the P-64s and make it a little oversize to custion the recoil. Big bucks to retool and retrofit the assemply line to mfg them, but worth a try. I sent Guy Hogue an e-mail to see if they would consider this. Sgt P.
Last edited by Sgt P on September 26th, 2009, 10:23 am, edited 1 time in total.
- kilogulf59
- Member
- Posts: 51
- Joined: March 4th, 2008, 6:03 pm
- Location: Juneau County Wisconsin
- Contact:
Grips for CCW & Recoil
Good idea and I'm in.
Grips for CCW & Recoil
Sadly I did hear back from Hogue Grips yesterday. They confirmed that they will not be producing any soft rubber oversized grips for the P-64 due to the cost of re-tooling, injection molding, etc, etc. Oh well, maybe we can find someone who could custom make them one set at a time. Sgt P.
Grips for CCW & Recoil
i have a hogue on my 64. i had to cut it diwn and it would be nice if it was a bit tighter, but it works.
![Image](http://i864.photobucket.com/albums/ab207/jhandy321/IMG_2999.jpg)
![Image](http://i864.photobucket.com/albums/ab207/jhandy321/IMG_2999.jpg)