loaded round pin????

leadhead2 · Post by **leadhead2** » January 29th, 2010, 10:14 pm

Hi guys,
I picked up a like new p64 yesterday and have a queston.
I striped it down to clean, and don't remember which way
the loaded round indicator goes. I installed it with the bevel
toward the firing pin. Is this right? It works but the pin doesn't
stick out very far. Could someone check to see if i'm right?
Thanks,
Denny

brock123 · Post by **brock123** » January 30th, 2010, 12:08 am

I don't recall of the top of my head only tore mine down once because I have had it less then a week but this should show you.

http://p64resource.com/board/P64_Assembly.zip

leadhead2 · Post by **leadhead2** » January 30th, 2010, 9:52 am

Yea, I've seen that, but it really doesn't show the other end where the bevel is.
Denny

leadhead2 · Post by **leadhead2** » January 30th, 2010, 8:25 pm

Hey guys, can't someone look at there gun and tell me which way that damm
pin goes in?
Denny

stover · Post by **stover** » January 30th, 2010, 9:40 pm

Mine has the flat part down.

leadhead2 · Post by **leadhead2** » January 30th, 2010, 10:11 pm

Thank you very much stover. I guess I have it in right.
Denny

stover · Post by **stover** » January 31st, 2010, 2:18 am

Awesome, it just happened to be laying on the table next to me when I saw your post.

juniustaylor · Post by **juniustaylor** » February 14th, 2010, 6:09 am

The sloped side is toward the firing pin. The top of the slope is against the top of the slide. The pin is only supposed to protrude .100" to the rear, that info is straight from the manual.

The Unofficial P64 Resource Forum