The Unofficial P64 Resource Forum

Hi there. New here, and hope someone can help out with my new P64. Just installed a new trigger spring, but having difficulty reassembling. The disconnector arm won't stay in place to release the trigger. Any suggestions? If I hold it in place, it will engage. If I hold it upside down, it will sometimes engage. But when I go to put the grips on, it falls out of place. Any suggestions on how to get this back together? Thanks.

Did you use this guide?
They have some trick about how to set the springs to get it back together.
Worked for me.
http://www.p64resource.com/board/P64_%20Assembly.pdf

limbo2

http://www.p64resource.com/goods.php

go to the bottom of page

NORM