disconnector arm hang up?

chuck · Post by **chuck** » January 20th, 2009, 7:39 pm

Anybody have issues with their disconnector arm not always working right, the trigger moves freely without engaging the trigger arm? Is there a fix?

thanks,

chuck

Post by **normsutton** » January 21st, 2009, 7:20 am

chuck

the trigger return spring is off the bar or is broken should look like this

http://p64.proboards67.com/index.cgi?bo ... hread=1822

NORM

chuck · Post by **chuck** » January 21st, 2009, 12:01 pm

the trigger spring works, the trigger has tension, its the disconnector arm that doesn't always "pop" up. When viewed from the back of the pistol, the hammer is cocked and the disconnector that rests against the slide doesn't always return to its up most position allowing the trigger to be pulled but it doesn't engage the flat spring on the right side of the frame. Working the trigger back and forth returns the disconnector after a couple of times.

thanks,

chuck

lcberlin · Post by **lcberlin** » January 21st, 2009, 2:25 pm

You might try reading this thread...

http://p64.proboards67.com/index.cgi?bo ... hread=2342

Or this one...

http://p64.proboards67.com/index.cgi?bo ... hread=2359

Look at the photos and see if they help with your issue. The Official Manual/Disassembly thread is another good thing to look at.

If that don't work, take good pictures and post them.

chuck · Post by **chuck** » January 21st, 2009, 8:15 pm

thanks for the help have read the threads, have cleaned, looked at the inside of the slide for burrs...have played more with my p64 and found that with the magazine out and the hammer cocked I can pull the slide back, maybe an half inch, ride the slide forward and the disconnector doesn't return to the up most position and it takes working the trigger back and forth or using the safety to get the disconncetor back in its upmost position. Weak spring?

The Unofficial P64 Resource Forum