Magazine release

[james832]

Have read every thread on entire message board, but this is my first post. I purchased a p-64 several months back. There were several issues that needed "fine tuning" on this particular pistol. One thing that was more difficult than I thought nessasary , for me at least, was getting my finger on the magazine release. To solve this I beveled the back of the plastic bottom by approximatly one fourth of the height, and then put a bigger radius on the three fourths height that was left. This helped quite a bit. Next I belled out the bottom of the plastic grips around the release button. This was actually little more than rounding off the sharp edges of the moulded grips. I dont know what others have thought of this but it worked for me. If I were going to use it as a carry piece I would consider it a good modification.

[normsutton]

james832

welcome


need to see some pix of this mod.


NORM

[blacktop]

Sounds like a good mod. +1 on the pic request!

[james832]

I having problems with the camera so no pictures for now