Mag spring source or Wolf Springs slow waltz?

[nicksterdemus]

Any sources or are we @ WS mercy?

[normsutton]

nicksterdemus

We can't get them to make a recoil spring or a hammer spring just for the the P-64 and now you want a mag spring
good luck

[nicksterdemus]

Hey NORM! I was just wonderin' out loud. Thought some1 might have rigged a mag spring from another pistol. I know thru readin' old posts that Wolf Springs have been aware of the 64 issues 4 @ least 14 months. I've been thinkin' 'bout ordering a 21# Mak recoil spring n cuttin' it down 2 see what shakes. The other 64 should be in any day now & I'll have that 2 mess w/along w/ij70 of my bros that I need 2 tear down n slick up. Cuttin' 1 n 1/2 turns off the mainspring worked like a charm 4 me. If I could just figger out how 2 add tension 2 da recoil I'd be in like Flynn...............................

[normsutton]

nick

I have know idea if a mak . spring will work or not , 21#'s might be to much , but give it a try will never know if someone doesn't try it. if you got a mak check the mag spring in it . later to night I will check some of my other autos mags .



NORM

[nicksterdemus]

NORM! Hey I was readin' on a Mak board that some1 had used a 21# recoil on the 64. Said due 2 the larger diameter wire that the cut length was shorter than the original 64 spring but seemed 2 work. On the mags I've a couple of xtras & don't mind paying 10 bucks 4 new ones just hate 2 pay that much if I only need the spring..............

[normsutton]

NICK

the PA- 63 mag spring are the same length same width the wire is a little thinker you would have to reshaping the ends of the springs by heating and then bending but can be done

NORM

[nicksterdemus]

Thanks NORM! I'm making a list & checking it a dozen times before I place an order w/Wolf Springs. Just when I think I'm ready I remember something else or a new gun pops up that has needs..............