Slight problem with my new P-64

[KonaCreek]

Hi everyone,

Hope you're all well.

I was cleaning my P-64 yesterday and when I got the slide back on, I noticed a little hang-up - as in the slide wasn't fully forward. I managed to take a video with my camera, so hopefully I'll be able to link it. If I rack the p-64 and let go, it goes forward, but if I gently let the slide down, it hangs at the last 1/2 in. Just a little pressure of my thumb on the back of the slide will rack it the rest of the way with a loud click. The safety is engaged.

Thanks for any insight/help.

[Curly1]

Mines does the same thing. The loud click is the decocker doing it's job in dropping the hammer

Working as designed.

[KonaCreek]

Here are some pics:

[KonaCreek]

Here it slams forward when I give it light pressure on the back of the slide - the hammer also goes forward.

[Geep]

As Curly1 stated, looks like it's working as it should be. My P64 is very tight and does the same thing. If I run the slide forward very slowly, it catches the hammer in the last 1/2 inch or so to decock, but closes if I push slightly on the back of the slide. It will not do that when shooting, the safe is off or if you rack it normally.

[KonaCreek]

Whew! That's a relief! Y'all are great! THANK YOU BOTH!