P64 IWB Holster by JMG

pirate · Post by **pirate** » July 27th, 2009, 6:14 pm

Just received my JMG Holster for my P64. I have to say for a $30 holster its very well made. Not the best quality holster I own but it fits nicely and should do the job. I like it.
http://www.jmgholsters.com/iwb.htm

amd6547 · Post by **amd6547** » July 27th, 2009, 8:22 pm

You could wet mold it...pretty easy and makes it fit better.

Post by **dfunk** » July 27th, 2009, 8:57 pm

It would depend on the topcoat - if it's acrylic or the likes, it won't want to take in the water.

thesurf777 · Post by **thesurf777** » July 28th, 2009, 9:41 am

Looks nice. You can spray the inside with silicon and put the gun in and out about twenty times. It will make a better fit, and makes it much easier to pull. A leather smith at SC gun fair told me to do this and it worked well for my S&W airweight 38 in a tuck leather. I am looking for a tuck for the P-64. Do they make a tuck similar to this one? and that is all I will do to it for a better fit. just a thought...

carlhenry · Post by **carlhenry** » July 31st, 2009, 10:18 pm

hey there where did you get that black fabric on your grip?

semtex · Post by **semtex** » July 31st, 2009, 10:31 pm

carlhenry wrote:hey there where did you get that black fabric on your grip?

It looks more to me like a Hogue universal rubber grip. I use them on my Glock and CZ-52. Some people like them, and some people don't.

stover · Post by **stover** » August 1st, 2009, 12:36 pm

I have a Hogue Handal Jr. universal grip on mine and I like it ok. There is a long thread discussing the best approach to putting them on a P64 some where on the board.

The Unofficial P64 Resource Forum