Just got a P64 have questions

bud84lightman · Post by **bud84lightman** » December 13th, 2008, 2:46 pm

hey guys i just bought a 1971 p64 and really like it and my only problem is when i fire off about 3 shots the safety/de-cocking lever falls down and not sure what i need to do to fix it

blinddog · Post by **blinddog** » December 13th, 2008, 11:01 pm

Check the detent. Holding the gun like you would shoot it, it is on the left hand side in the slide. Just look and you will see it, take it out, however, do this in a clear plastic bag or thou might be looking for a detent because there is a spring behind it. Take this out carefully and you will notice a little thing that is shaped like a bullet. If it is rounded off thats your problem. All you have to do is carefully bring it back to a point without loosing length of detent. Also look at the grooves (they look like cat eyes) that are on the safety its self. Make sure that they dont have any burrs. If they do just get a small drill bit and by hand turn it several times in the groove and it should work like a champ. On the message board you will see one that says Official manual -dissambly-documents . This tells you step by step on exactly how to do this procedure. Good luck, it ain't hard when you get started just do it in a plastic bag. Trust me.

bud84lightman · Post by **bud84lightman** » December 14th, 2008, 12:02 am

ok thanks for the input....ho long does it take to break the slide down and fix this?

Post by **normsutton** » December 14th, 2008, 8:00 am

bud84lightman

TAKE LOOK AT THIS TREAD

http://p64.proboards67.com/index.cgi?bo ... 127&page=1

NORM

bud84lightman · Post by **bud84lightman** » December 14th, 2008, 6:09 pm

k guys i just took my gun apart and the "detent" if thas what it is called it is rounded almost flat what is the best thing to use to bring back the point?

blinddog · Post by **blinddog** » December 14th, 2008, 9:36 pm

As I see it, you could try to reshape it, but, you could make it too short or get up with norm sutton and he can tell you how to make or, heck the may already have one made. Norm is the resident gunsmith for this board and a darn fine one I might add.

blinddog

bud84lightman · Post by **bud84lightman** » December 14th, 2008, 9:46 pm

well i took it out and filed it to somewhat of a point and re-installed it now it is alot stiffer but havent had the chance to shoot it and see if the safety falls....if it does does any1 know where i can order a new plunger and spring? thanks for all the input so far

Post by **normsutton** » December 15th, 2008, 6:13 am

bud84lightman

try here for parts

http://www.tnguns.com/shop/index.php?ma ... b9e917bad3

NORM

bud84lightman · Post by **bud84lightman** » December 15th, 2008, 4:53 pm

hey norm the parts list u sent didn't have the savety plunger on it do u know of any where else i could find one

Post by **normsutton** » December 15th, 2008, 5:38 pm

bud84lightman
did you call them
you can try this someone on the board said it fit
http://www.e-gunparts.com/product.asp?c ... SKU=205550

NORM

The Unofficial P64 Resource Forum