CZ 52 9mm conversion?

gunneyrabbit · Post by **gunneyrabbit** » September 17th, 2007, 11:10 pm

Has anyone converted their CZ52 to 9mm? If so what problems did you run into with the extractor and magazine feed, what changes needed to be done for successful function?
G.R.

Post by **normsutton** » September 18th, 2007, 4:51 am

G.R.

you might try here

http://p201.ezboard.com/fczechpistols82792frm59?page=1

NORM

gunneyrabbit · Post by **gunneyrabbit** » September 18th, 2007, 10:27 pm

You came across again NORM, thanks for the heads up. Just ordered the barrel from "The Sportsman's Guide" on line catalog. I'll post photo's and give a range report when I get it all put together. ;D
G.R.

Post by **normsutton** » September 19th, 2007, 4:43 am

G.R.

there is another web site you may get some answers from ,but I think your going to have to ask they just had a big move and lost a lot of info

http://forums.gunboards.com/forumdisplay.php?f=12

I haven't done this change so I can't give you the answers you need

NORM

gunneyrabbit · Post by **gunneyrabbit** » September 19th, 2007, 3:51 pm

NORM, thanks for sharing the site, I have already picked up a couple of gems think I can put to use, this site is packed full of information.
G.R.

doyle · Post by **doyle** » September 24th, 2007, 11:49 am

Speaking of the conversion - does anyone have either pictures or a very accurate description of the way to modify the extractor? The description over on the Makarov forum is way too vague to actually use.

The Unofficial P64 Resource Forum