May Have Damage in Trigger Group

timbre · Post by **timbre** » May 21st, 2007, 9:02 am

As I am prone to do, I may have damaged something I was touching! I was cleaning the P-64 in basic fieldstrip and when I was finished, the trigger pulls but there is no hammer action. What did I break? I know nothing of gunsmithing or repair. :'(

Post by **normsutton** » May 21st, 2007, 9:14 am

timbre

I think what you've done is knock the trigger return spring off the trigger bar this is common
give me your email address and I'll send you instruction how to put back on and my phone #

NORM

timbre · Post by **timbre** » May 21st, 2007, 9:23 am

Thanks, Norm! I've sent an pm to you.

Post by **normsutton** » May 21st, 2007, 9:27 am

timbre
SENT INSTUCTIONS
ANY PROBLEMS GIVE ME A CALL I CAN TALKE YOU THOUGH IT
NORM

The Unofficial P64 Resource Forum