The Unofficial P64 Resource Forum

Thanks for all the input everyone! After taking it apart and looking at it for a while, I believe the actual cause of the apparent cant of the safety is a combination of dfunk and boomer's posts. I appears that a)the cutout in the rear of the slide is indeed misaligned, with the right side being mil...

I was wondering about the milling aspect too. I don't see any appreciable wear on the safety or on the contact surfaces in the slide that would cause it to slant like that. I may take it all apart again tomorrow and stare at it for a while and see if anything jumps out. Thanks again.

--Rick

Thanks for the pic of the broken safety. My safety is still intact and that particular piece is not broken off. I just pulled the slide off and took a peek in it to double check. Didn't remove the safety again because my fingers aren't recovered from putting it back together last night. I appreciate...

Hi guys, I've had my eye on a P64 for a while and have been reading lots of great posts on this board recently. Thanks to everyone for their contributions. A couple of days ago I had the chance to trade off a FEG P9R which I absolutely HATED for a P64 (1976) at the local Gander Mountain. I normally ...