Page 1 of 1
loaded round pin????
Posted: January 29th, 2010, 10:14 pm
by leadhead2
Hi guys,
I picked up a like new p64 yesterday and have a queston.
I striped it down to clean, and don't remember which way
the loaded round indicator goes. I installed it with the bevel
toward the firing pin. Is this right? It works but the pin doesn't
stick out very far. Could someone check to see if i'm right?
Thanks,
Denny
loaded round pin????
Posted: January 30th, 2010, 12:08 am
by brock123
I don't recall of the top of my head only tore mine down once because I have had it less then a week but this should show you.
http://p64resource.com/board/P64_Assembly.zip
loaded round pin????
Posted: January 30th, 2010, 9:52 am
by leadhead2
Yea, I've seen that, but it really doesn't show the other end where the bevel is.
Denny
loaded round pin????
Posted: January 30th, 2010, 8:25 pm
by leadhead2
Hey guys, can't someone look at there gun and tell me which way that damm
pin goes in?
Denny
loaded round pin????
Posted: January 30th, 2010, 9:40 pm
by stover
Mine has the flat part down.
loaded round pin????
Posted: January 30th, 2010, 10:11 pm
by leadhead2
Thank you very much stover. I guess I have it in right.
Denny
loaded round pin????
Posted: January 31st, 2010, 2:18 am
by stover
Awesome, it just happened to be laying on the table next to me when I saw your post.
loaded round pin????
Posted: February 14th, 2010, 6:09 am
by juniustaylor
The sloped side is toward the firing pin. The top of the slope is against the top of the slide. The pin is only supposed to protrude .100" to the rear, that info is straight from the manual.