The Unofficial P64 Resource Forum

I'm picking up a 9mm barrel for a CZ52 from a forum member. I've read the CZ52 page over at Makarov.com and have seen the information on filing down the extractor to allow for better feeding of the shorter 9mm shell. Only - the instructions are not very clear.

I think they are saying that as the extractor is laying flat, you would round over the bottom edge of the forward left side portion.

Has anybody ever made this modification themselves? Before I try it, I think I'll pick up a spare extractor. I could modify it leaving the original un-modified.

doyle

I haven't made this mod but someone on this
forum has
http://p201.ezboard.com/fczechpistols82792frm59?page=1

I'm sure of that ,you will have to find it

let us know

NORM

Here's the thread: http://p201.ezboard.com/fczechpistols82 ... =825.topic

doyle

I haven't made this mod but someone on this
forum has
http://p201.ezboard.com/fczechpistols82792frm59?page=1

I'm sure of that, you will have to find it

let us know

NORM

doyle

you also might want to try this thread too there are a lot of threads on 9mm barrels

http://p201.ezboard.com/9mm-problems/fc ... howMessage?
topicID=667.topic

NORM

Thanks guys. Keep up the suggestions. I'd love it if someone has successful pictures.