Looking for next step in trimming 9mm brass
Posted: May 20th, 2017, 12:40 pm
I tumbled, deprimmed and resized the brass using the 9x18 die, and just finished expanding the case. Now I am ready to trim with my Lyman case trimmer with the 9x18 pilot.
After trimming and checking for proper length, would my next step be charging and seating or do I need to do anything else?
Also, should I use the Lee factory crimp die?
Thanks for any response you can offer.
After trimming and checking for proper length, would my next step be charging and seating or do I need to do anything else?
Also, should I use the Lee factory crimp die?
Thanks for any response you can offer.