I am confused with the sequence
Posted: April 10th, 2017, 1:35 am
I am going to start converting 9x19 to 9x18 cases. Would this be the proper sequence:
1. Tumble.
2. Deprime/case shaper with 9x18 die.
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
5. Charge case.
6. Seat bullet
Is this the sequence to use?
Thanks
1. Tumble.
2. Deprime/case shaper with 9x18 die.
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
5. Charge case.
6. Seat bullet
Is this the sequence to use?
Thanks