Mag sticks?
Posted: December 26th, 2011, 9:57 pm
Hi when I tighten the grips securely the mag no longer ejects. Anyone had this problem? Ok to sand down the inside of the grips , thanks
Yeah, that problem had been discussed on here. The grips don't have to be smoked down, however, you can possibly remove a bit of plastic from the grips to get them to tighten up securely but not grab the magazine. You may look at some form of white-out or something similar to put on the magazine in a couple spots. Then insert it in and see where it got rubbed off and investigate those areas on the grips to see if it corresponds.
Good luck!