The Unofficial P64 Resource Forum

I have talked to the guys at Wolf and aparently due to lack of popularity of the P-64 there is no rush to create a Main Spring or Recoil Spring. We really need an engineered heavier recoil spring since most of the ammo here is 95 grain or heavier. I am concerned about the frame in my little gem. Perhaps if all of us call Wolf (800-545-0077) and show interest, they will design a good set of springs. Magazine springs would be nice too! Just an idea!

You will have to use springs made for the Walther PPK and HK P-7 from Wolff. There are discussions about this subject on this site. The mag spring feels pretty stiff to me, so I doubt you'll need a replacement any time soon. . . . PshootR . . .

I wrote them an email and got the response below. I figured the same, more people who contact them the better. They make good products, but honestly, I don't think that much engineering is required for many of their products. I bet they do test quite a bit after they make something.

Sorry Steve, but currently there are no springs available for your pistol. We intend to produce springs in the future but I have no definite date for production.

I got the same answer from them about six months ago, so I wouldn't hold your breath. . . . PshootR . . .

just asked them again:

==================

>Hi,
>almost a year ago I received a response that you are considering making
>springs for this gun, but no definet dates where set.
>
>I have since then saw other people getting similar response.
>So wanted to know if you are planning to make any replacement springs
>for this specific gun model.
>
>Thanks in advance
>
>
No recoil springs are available at this time. R&D is moving slowly due
to a heavy production schedule. Walther PPK hammer springs in reduced
power versions can be used to lighten the trigger pull on the P-64. Gun
specific springs for your model are still on a short list with no set
date for availability.

Hey all,

Here is a link to a company that will make any spring. You give them the specs. If someone was really motivated, they could get a spring made by these guys and resell them.....

I wonder if Wolff uses these guys?

http://www.springsfast.com/cm_compression.htm