The Unofficial P64 Resource Forum

I have a trigger problem on a PA-63. I took the slide off to give it and the frame a wipe down an a lube. When I put the slide back on the hammer decided that it would go back also.( no slack in the trigger) I was looking at a PA-63 with the slide on and the trigger back. I pulled the trigger (seemed the thing to do)and the hammer did the proper thing and the trigger fell to natural position. I pulled the slide back and the trigger stuck in the back position again. I held the hammer pulled the trigger and the hammer fell and the trigger went back to the position that it is suppose to be in. I didn't take anything apart that I am aware of. Nothing fell out. (I work on a white cloth). Has anyone had this problem happen to them before? Does anyone have a suggestion or a comment? Please if anyone has an idea I sure would like to hear it.

blinddog

take the grips off and see if the sear push pins are there



NORM

Yeah Norm, they are there. I didn't take them out, but I did check to make sure they were working. Is there any way they shifted or maybe something moved. I did rack the slide without the grips on.
Thank you for helping me Norm.
Doug

help! ???

blinddog

if you want call me

NORM