The Unofficial P64 Resource Forum

I just picked this up at a show today and am looking for another mag. The P63 mags fit, but a bit long. Any ideas where to find one?
Also...what about springs? Can I use P63 hammer and firing pin springs, or will they be way off?
raz

I'd suggest looking here first: if you can't find it listed, call them: their inventory is pretty substantial.

http://www.e-gunparts.com/

raz

the springs will work , you will have to cut the recoil spring to the size of the original spring
but will work

NORM

Thanks, folks. So far it is working fine...I'll need to see if Dennis can do grips with a thumb rest.
raz

He has these. http://www.marschalgrips.com/



The 22# Wolff recoil spring for the P-64 will work, but you must cut about 1 coil off of it.

Mags are just about impossible to find, but the PA-63 mags work, they just hang down.

Hoosier Gun Works claims they have 4 Triple K mags with finger extensions for $22 each. About half way down the page.
http://www.hoosiergunworks.com/catalog/ ... istol.html

Thanks again. I've got Dennis' grips on my P64 and two CZ82s. I'd like a thumb rest for the P63 or SMC918. Maybe I can talk him into making them. I've used the 63 mags....sort of awkward.
Is the SMC 380 or the Triple K" the same mag as the 918?
raz

As long as it is a 6 round FEG mag for either the .380 or Mak it should be the same. The .380 and 9mm Mak use the same mag. They are either 6 round for the small frame guns or 7 round for the standard size pistols.