The Unofficial P64 Resource Forum

I have read the message board regarding the difficult DA trigger pull. However, I have noticed something on my P64 that is different from the one my brother has. When I am having the difficulty pulling the trigger in DA, I noticed that my hammer does not go back as far as my brother's pistol does. I just received mine today, so I'm not sure that this will effect the way it performs. Has anyone noticed this, along with the extremely difficult trigger pull?

Is the hammer round or triangular?? I just got mine today as well. Get it from J&G?? It is tough, no doubt. But not nearly as bad as I thought it would be. I'm changing the hammer spring and recoil spring. I'll set you know.

Sorry about the last reply, index finger not doing too well after trying to pull the trigger on my P-64. Yes, I asked specifically for the triangle shaped hammer. I did purchase from J&G and noticed that mine was the only one of the lot that had this issue. I don't think that the hammer is going back far enough to strike the pin and discharge the weapon. I haven't fired it yet, so I don't know for sure. I really like the size and weight of the pistol and hope that it isn't a difficult issue to resolve. I have already ordered my package to change out the hammer and recoil spring as well.

Just changed out the recoil spring. Would have changed out the hammer spring except my good 1/16 punch is missing. My number one suspect is in Iraq right now. I won't bother him over this right now. I'll buy a set of gunsmith tool kit in the AM, kind'a wish he was here so I could yell at him.