The Unofficial P64 Resource Forum

New P 64...$165...1973...seemed like a good deal.
However, the DA trigger actually STOPS about 3/4 though the pull. I've dropped the hammer spring to an 18#, but the issue remains.
HELP!! There must be a mechanical issue in the hammer/trigger components.
On SA the trigger works fine.
raz

Thanks to Norm for good suggestions. I disassembled the entire gun, cleaned it thoroughly, replaced both the return and slide springs and it is now working on DA. It is still very strong, but I think that is just the 64 talking.

raz


it could be the trigger return spring, it controls the trigger bar , also did you clean the gun yet

NORM

Norm:
I soaked it overnight in "red" gun-cleaner and sprayed it down with brake cleaner...I've changed all the springs in my other 64 and did not have this issue with it at all.
Which one is the trigger return spring?
raz

raz

right here

http://p64.proboards67.com/index.cgi?bo ... hread=1822


NORM

Norm:
I'll PM you.
raz

raz

was the return spring broken

NORM

Thanks, Norm...see modified post.