The Unofficial P64 Resource Forum

I lost my safety plunger and was wondering if one out of a PPK 380 would fit? Beings the FEG is a clone of the PPK

What do you think? ???

ppk



Pa 63

P-64 parts, illustrated:
http://www.tnguns.com/shop/index.php?ma ... a8ff91d8f1

FEG parts, illustrated:
http://www.buymilsurp.com/pistol-parts- ... _3204.html

Walther Parts, illustrated:
http://www.e-gunparts.com/productschem. ... l=2100zPPK

jon321
yes I think it will work you will have to cut the tail off of it and don't put in the gun that way put in the gun this way

the safety plunger goes in from the back of the extractor tube first, though to safety hole then you put the safety in, I've also made these out a nail close to the same size as the plunger with a drill and small file to turn it down then take the part heat it to a cherry red and drop in oil to temper it

NORM

Hey Norm, didn't someone try to use a ppk detent and it was to large?

blinddog

blinddog

can't remember ,I know its to long,

NORM

I think it was too fat also. I don't remember who it was but I think they wound up getting the detent from one of the sites that handle P64 parts. Memodry ain't what it use to be. ;D

blinddog

blinddog


I think SHONA has them at http://www.ssmedwi.com/misc.page4.htm she calls them a Safety Ball , AP9/APK Parts are pretty much the same gun as A PA-63 just in 380
and http://www.charlesdaly.com/ used to import all of FEG guns and still have some parts

NORM