Page 1 of 1
p64 single action problem
Posted: May 22nd, 2006, 7:14 pm
by m48yugo
Took my new p64 (from SOG) to the range. accuracy was very surprising! Used s and b ammo. After a box of ammo pulled trigger
and hammer would not fall! Hammer would sometimes drop and
sometimes it would'nt. Took the gun apart and noticed the little
metal peice that should? contact the trigger bar flooping around.
If this metal peice is up the hammer falls if not it won't. is thier a spring missing? fell out? this is in the frame? any ideas guys? thanks.
Doug
p64 single action problem
Posted: May 22nd, 2006, 7:37 pm
by normsutton
SOUND LIKE THE TREGGER RETURN SPING CAME OFF THAT METAL PEICE YOU TALKING ABOUT
NORM
p64 single action problem
Posted: May 22nd, 2006, 8:09 pm
by normsutton
THE METAL PEICE I THINK IT'S CALLED A TRIGGER BAR
AT ONE END OF IT GOES INTO THE TREGGER AND RIGHT AFTER THAT THERE IS LITTLE PEICE THAT STICKS IN AND THE TAIL OF THE TREGGER SPRING PUSHES UP ON IT
HOPE THAT HELPS
I COULD TELL YOU OVER PHONE
EMAIL ME YOUR PHONE # AND I CALL YOU TOMARROW NIGHT GIVE ME A TIME TO CALL
NORMSUTTON@AOL.COM
NORM
p64 single action problem
Posted: May 22nd, 2006, 9:24 pm
by m48yugo
looked in the p64 manual, the loose peice is the disconnector. Should
the trigger bar be attached to the trigger bar with a spring? What should keep the disconnector in the "up" position when the hammer is cocked?
p64 single action problem
Posted: May 23rd, 2006, 4:24 am
by normsutton
THE TREGGER RETURN SPRING DOSE THAT LOOK AT THIS PICTURE
http://img229.imageshack.us/my.php?image=40uo.jpg
THE ONLY WAY YOU CAN SEE THIS ON YOUR GUN IS TO TAKE SLIDE OFF AND THEN TAKE THE SLIDE STOP OFF THEN YOU SEE A WINDOW IN FRAME
YOU COULD HAVE A BROKEN TREGGER RETRUNE SPRING
NORM
