SAM 45
Posted: September 5th, 2008, 3:23 pm
pick this SAM 45 up last week end 299.50 OTD
before
after
NORM
before
after
NORM
Page 1 of 1
SAM 45
Posted: September 5th, 2008, 3:42 pm
Nice!
SAM 45
Posted: September 5th, 2008, 5:14 pm
Where do you find those good deals? I walk for hours and never see anything close to what you find.
SAM 45
Posted: September 5th, 2008, 9:47 pm
Hi Norm, very nice, did not know that Sam's came with 30 LPI checkering both front and rear? If that was an after market add it was a very nice one and made the purchase that much sweeter, like the holster also, how do you do it?
Very Cool,
G.R.
P.S.
If you did the checkering please PM me with your address as I have a job for you.
G.R.
Very Cool,
G.R.
P.S.
If you did the checkering please PM me with your address as I have a job for you.
G.R.
SAM 45
Posted: September 6th, 2008, 5:41 am
DF
thanks
dwd
if you knottiest I buy a lot of used guns something I can work on , when I bought this one I went to two guns show's and then finding it in a gun shop, papabear is the one to watch he finds the best deals
GR
if you look at the first pix you see the checkering and the last pix its not there I don't like checkering I took it off , it felt like I was holding a course wood file may hand,
before
after
NORM
thanks
dwd
if you knottiest I buy a lot of used guns something I can work on , when I bought this one I went to two guns show's and then finding it in a gun shop, papabear is the one to watch he finds the best deals
GR
if you look at the first pix you see the checkering and the last pix its not there I don't like checkering I took it off , it felt like I was holding a course wood file may hand,
before
after
NORM
SAM 45
Posted: September 6th, 2008, 10:37 am
Norm, I did notice the change in the frame and thought the photo's were just out of sequence, how did you remove the checkering?
SAM 45
Posted: September 6th, 2008, 11:45 am
GR
I had to use a grinding wheel the a sand paper wheel then I a fine steel wire wheel then sand blasted it
NORM
I had to use a grinding wheel the a sand paper wheel then I a fine steel wire wheel then sand blasted it
NORM
SAM 45
Posted: September 7th, 2008, 10:01 pm
Jeez Norm, I wish I had your talent!
How long did it take you to learn your craft?
G.R.
How long did it take you to learn your craft?
G.R.
SAM 45
Posted: September 8th, 2008, 5:31 am
G.R.
59 years and still learning and I don't show my mistakes
NORM
59 years and still learning and I don't show my mistakes
NORM
SAM 45
Posted: September 9th, 2008, 11:00 pm
Good to here that Norm, I new we would eventually have something in common, LOL. It's nice to know that I'm not the only one!
G.R. ;D
G.R. ;D