The Unofficial P64 Resource Forum

Anyone know where I can get a replacement safety. Mine somehow broke into two pieces and will no longer decock :-/

ufcritter

Send the slide back to the place you bought it they should replace it at no charge


NORM

That would be SOG. I guess I'll try contacting them and seeing what they do. I'll let you know what happens.

Looks like it will be an exchange. I guess they dont have spare parts

ufcritter
these safeties were cast and then milled then harden , I think some were cast to hot so the metal in them crystallized you have the 4th one I have heard about . were you dry fring the gun with the stock sping with out any snap caps in it when broke.
WE ALL NEED TO KNOW

NORM

"Looks like it will be an exchange." Dang it & after all that work cleaning it up. Could be worse eh?

Actually, I had cut down the mainspring by 2.5 coils prior to dry firing. I guess I wont be dry firing these anymore. Fortunately, I ordered 2 pistols so I'll have one to shoot while this one goes back to SOG.

"cut down the mainspring by 2.5 coils "

I've been gettin' grief 4, 3/4-1 n1 /2 turns.

Do the P-64's have a special problem with loose safeties? At the height of their importation, I saw a dealer with a whole box of them. Most had loose safeties. I sorted through them and bought the tightest one. However, I need to be careful that the safety does not reengage while I am firing. It usually doesn't happen with the first clip, but eventually the safety falls down, you need to push up the safety, and you need to pull double action again. Do any of you have a similar problem?

Do any of you have a similar problem?

I DID have that problem, fixed now. See this thread for some ideas and fixes:

http://p64.proboards67.com/index.cgi?bo ... 1133831696

Good luck, and welcome to the forum!

stibnite

Thanks for the tip and the welcome. The thread was very helpful.