The Unofficial P64 Resource Forum

Wow

Now, I've left you alone for a couple of months, on here, but you never miss a chance to put me down or be unfriendly.

Hmmm, I read the messages in this thread and never perceived that anyone was putting anyone else down. I figured the differences in opinion were perhaps from varying quality control.

In my limited expirience with 9x18 I used two loads: 95 grain FMJ from S&B for plinking, and 115 grain HP from Silver Bear. Neither of them caused any problems. Silver Bear comes from same lot I got while ago. It was made by LVE, and batch code is "P 02-01-02" (P should be in cyrylic).
I had a bad expirience with Silver Bear in 30.06. Can't tell you lot or manufacturer, 'cause I got rid of it right then. My Garand had constand stopages, at one point I was not able to eject e-clip with five rounds remaining. Had to cycle them manualy.
Thru it all it was very acurate ammo. I should have kept it for Springfield '03 I got from CMP.

Hmmm, I read the messages in this thread and never perceived that anyone was putting anyone else down.

Yeah, me either. My first thought was about this thread. Note the date... (http://p64.proboards67.com/index.cgi?bo ... 165&page=1)

So here's the deal...
I have respect for the both of you. You are both long-term members that have a good reputation with me. I think that most of this flak is uncalled for and juvenile.
bzinggg, he doesn't like the ammo - neither do I. So? I fail to see how he was attacking you.
Public arguments are fine with me, that's between you guys - but not on my board. Go somewhere else and do that crap. This board has very little issues that require constant moderation - please don't change that for the 1000+ members on here. If there is a problem, PM me and we'll take care of it like gentlemen. Thanks.