Page 2 of 2
Re: V.04 grip with grip screw
Posted: January 4th, 2016, 2:20 am
by snailman153624
Like the OP, I just lined up the old grip with the new, and drilled through the hole in the old grip to get the new one where it needed to be. I just did this with a hand drill, and it went together perfectly. Just don't stab your fingers with a spinning drill bit.
Re: V.04 grip with grip screw
Posted: January 4th, 2016, 11:41 am
by robhic
That looks good (and much neater than my work!). Did you use screws or re-use the original screw and nut with counter-sinking? The photo is just a little dark on my end.
Re: V.04 grip with grip screw
Posted: January 4th, 2016, 1:36 pm
by Curly1
I sent Russ an email back in November to see how the next version was going.
Never heard back and he hasn't been on since the middle of October.
Re: V.04 grip with grip screw
Posted: February 8th, 2016, 12:55 pm
by SuperQ
Where can I get these grips I have tried tillander several times , but can get no response , makes me think he doesn't want to sell anything
Re: V.04 grip with grip screw
Posted: February 8th, 2016, 1:53 pm
by Ketchman
These grips are prototypes made by one of our (former?) members. And as Curly stated in the post before yours he has not been heard from in some time.