Thank You.
KG
What this?
What this?
Found recently, what this? Is it normal? Any recommendations please. Just 400 rds. Wear?
Thank You.
KG
Thank You.
KG
Last edited by kgeorge on May 21st, 2007, 10:35 pm, edited 1 time in total.
What this?
That piece is basically a pin that goes through the frame center which holds a spring and sear that breaks the hammer when the trigger is pulled. The recessed part above on that part where your arrow is drawn should be flush with the frame rails. Make sure that tiny tiny screw below is all the way tight (firm tightness not over tight). I have completely stripped and put back together 16 of these pistols and I have in 14 cases noticed that the screw needed tightning to hold that pin in place. And I would say yours looks a little worn. It should be ok just tighten the screw below it.
-Troy
-Troy
Last edited by brigade on May 21st, 2007, 11:31 pm, edited 1 time in total.
What this?
Thank you Troy for the positive information.
KG
KG