Ejector is making slide stuck

Mods and Fixes by P-64 users...
Post Reply
Jiovanni93
Posts: 3
Joined: October 4th, 2019, 12:34 am

Ejector is making slide stuck

Post by Jiovanni93 »

https://imgur.com/a/y2jdWr7
Picture 4 shows it best but the ejector is pressing against where the firing pin is held. Making the slide stuck I can’t lift the slide up to disassemble or field strip. Any way to move the ejector clear?
Jiovanni93
Posts: 3
Joined: October 4th, 2019, 12:34 am

Re: Ejector is making slide stuck

Post by Jiovanni93 »

The ejector is also referred to as slide stop. I got the ejector from translating the manual
GuitarmanNick
Member
Member
Posts: 197
Joined: March 19th, 2017, 10:04 am
Location: Marylandistan

Re: Ejector is making slide stuck

Post by GuitarmanNick »

To remove the slide, you must first pull the trigger guard down in the front and lock it open by pushing a little to either side. This will then allow you to pull the slide back far enough to lift and remove it.
User avatar
Curly1
Elite member
Elite member
Posts: 2529
Joined: September 20th, 2011, 11:35 pm
Location: Upstate NY

Re: Ejector is making slide stuck

Post by Curly1 »

I place a thin piece of wood between the frame and the trigger guard to keep the trigger guard locked open for disassembly.
Laugh Hard and Often.

Gary
Jiovanni93
Posts: 3
Joined: October 4th, 2019, 12:34 am

Re: Ejector is making slide stuck

Post by Jiovanni93 »

I have pulled the trigger guard out of lock position the slide is being held by the stop. If you look at the photos I believe the slide stop has been knocked out of place
GuitarmanNick
Member
Member
Posts: 197
Joined: March 19th, 2017, 10:04 am
Location: Marylandistan

Re: Ejector is making slide stuck

Post by GuitarmanNick »

Okay, now I see what you are talking about. It looks like the slide stop lever has somehow become wedged into the bolt face. This may keep the slide from going forward, but will not keep it from moving backward.

Here is a link to a thread on the topic:
viewtopic.php?t=5198
Post Reply