Took my PA 63 apart to clean it now the decocker is actin up
Took my PA 63 apart to clean it now the decocker is actin up
I have a PA-63 that will not allow the decocker to engage. It just will not let you thumb down the thing. Never had this problem before. Anyone have any advice? If I pull the hammer back just a hair and push down on the decocker it works fine. I'm at a loss.
-
- Global moderator
- Posts: 3575
- Joined: February 26th, 2006, 6:59 am
- Location: LAKELAND FL.
Re: Took my PA 63 apart to clean it now the decocker is acti
jamminjon
take the grips off , and see you have both sear pins in place
NORM
take the grips off , and see you have both sear pins in place
NORM
NORMSUTTON@AOL.COM
N.R.A. LIFE MEMBER 1976
N.R.A. LIFE MEMBER 1976
Re: Took my PA 63 apart to clean it now the decocker is acti
Yes both pins are in place.normsutton wrote:jamminjon
take the grips off , and see you have both sear pins in place
NORM
-
- Member
- Posts: 50
- Joined: April 21st, 2011, 4:47 am
- Location: Carroll County, Ohio
Re: Took my PA 63 apart to clean it now the decocker is acti
Just a shot in the dark, but did you replace the hammer spring on it? Wondering if there's somehow too much tension on the spring. Also, this should probably be in the "Other 9X18s" section. May find more knowledgeable people there.
Re: Took my PA 63 apart to clean it now the decocker is acti
Yes i replace it with a Wolf Hammer spring .BorisThespider wrote:Just a shot in the dark, but did you replace the hammer spring on it? Wondering if there's somehow too much tension on the spring. Also, this should probably be in the "Other 9X18s" section. May find more knowledgeable people there.
Re: Took my PA 63 apart to clean it now the decocker is acti
Moderators you can go ahead and delete this thread I put this one in the 9x18 forum. Thanks