Took my PA 63 apart to clean it now the decocker is actin up

[jamminjon]

I have a PA-63 that will not allow the decocker to engage. It just will not let you thumb down the thing. Never had this problem before. Anyone have any advice? If I pull the hammer back just a hair and push down on the decocker it works fine. I'm at a loss.

[normsutton]

jamminjon
take the grips off , and see you have both sear pins in place

NORM

[jamminjon]

jamminjon
take the grips off , and see you have both sear pins in place

NORM

Yes both pins are in place.

[BorisThespider]

Just a shot in the dark, but did you replace the hammer spring on it? Wondering if there's somehow too much tension on the spring. Also, this should probably be in the "Other 9X18s" section. May find more knowledgeable people there.

[jamminjon]

Just a shot in the dark, but did you replace the hammer spring on it? Wondering if there's somehow too much tension on the spring. Also, this should probably be in the "Other 9X18s" section. May find more knowledgeable people there.

Yes i replace it with a Wolf Hammer spring .

[jamminjon]

Moderators you can go ahead and delete this thread I put this one in the 9x18 forum. Thanks