V.04 grip with grip screw

[snailman153624]

Like the OP, I just lined up the old grip with the new, and drilled through the hole in the old grip to get the new one where it needed to be. I just did this with a hand drill, and it went together perfectly. Just don't stab your fingers with a spinning drill bit.

[robhic]

That looks good (and much neater than my work!). Did you use screws or re-use the original screw and nut with counter-sinking? The photo is just a little dark on my end.

[Curly1]

I sent Russ an email back in November to see how the next version was going.

Never heard back and he hasn't been on since the middle of October.

[SuperQ]

Where can I get these grips I have tried tillander several times , but can get no response , makes me think he doesn't want to sell anything

[Ketchman]

These grips are prototypes made by one of our (former?) members. And as Curly stated in the post before yours he has not been heard from in some time.