I am having trouble replacing the slide to the frame the slide isn't lower to be even to frame with the spring on it jumps over. Even tried to installed it with out the spring it seems tiled up and not level Has anyone else had this problem
Sent from my iPhone using Tapatalk
Can't replace the slide to the frame
-
- Posts: 2
- Joined: November 1st, 2014, 12:01 am
Re: Can't replace the slide to the frame
Make sure the slide stop lever is in its proper position. As long as you're using the same recoil spring, then this is the only part that will keep the slide from going all the way back and in the frame if it's not in proper spot.
-
- Posts: 2
- Joined: November 1st, 2014, 12:01 am
Re: Can't replace the slide to the frame
Thanks all it needed was a little downward pressure.Replaced hammer spring and extra power recoil spring to the range