The Unofficial P64 Resource Forum

That's a great photo, all four of my guns look about the same. Don't forget to file that hammer a little as it shows in the photo on my earlier post, you don't have to remove the hammer to file it.

If the safety turns freely I wouldn't worry about filing the slide. Just file the hammer a little as it shows in the photo on my earlier post, you don't have to remove the hammer to file it.

The peening causes the safety catch to be hard to turn, or in my case I could no longer turn the safety catch making the safety usless. I have four P-64's they all had the same problems to varying degrees. See my post and photo it just take a little filing of the hammer to fix the problem, if your s...

Just a quick note: the photo of the hammer I submitted was AFTER I filed the radius going any further would make it round. My camera won’t take as nice of a close up photo as juniustaylor does. I also noticed the hammer shown in the disassemble manual was quite rounded compared to mine.

After firing about 20 rounds the safety catch started to get hard to turn after another 20 rounds I could no longer rotate the safety catch. I went out to the shop and disassembled the gun and found the hammer slide and safety catch were damaged. The hammer slide was severally peened, as you will se...