The Unofficial P64 Resource Forum

OK, without doing anything I actually shot the gun. I can actually pull it through DA and get hits - but with the light trigger pull I end up double tapping without trying to actually do so. Bottom line is that I have to do something about the SA trigger pull. I think I will start by swapping in a h...

Having spent way to much time crafting 9x18 ammo using cut down 9x19 brass and hard cast bullets, the obvious problem with going heavier than about 100 grains is that you have to seat the bullet deeper in the case. The 9x18 was designed for short bullets seated much deeper than either the .380 or th...

It has been a while so I don't remember offhand which spring I put in. I got all three from Wolff and started with the lightest. It worked fine, so I left it in. I even if a lighter mainspring were available I would not want to use it. The SA pull is long, but light now and I would not like to see i...

I have replaced the mainspring and the single pull is fine now, but the double action pull is still very heavy right before it breaks. I know that some increased resistance before the trigger breaks is desirable, but this way past what is needed.

Has anyone found a solution to this problem?

Thanks!